Legacy Brighton Wagon AWD F4-2.5L SOHC (2000)
4. Install crankshaft sprocket.
5. Install camshaft sprocket No.1 and No.2. To lock camshaft, use ST.
ST 499207100 CAMSHAFT SPROCKET WRENCH
Tightening torque: ............................................................................................................................ 78+/-5 Nm (8.0+/-O.5 kg-m, 57.9+/-3.6 ft-lb)
CAUTION: Do not confuse left and right side camshaft sprockets during installation. The camshaft sprocket No.2 is identified by a
projection used to monitor camshaft position sensor.
AUTOMATIC BELT TENSION ADJUSTER ASSEMBLY AND BELT IDLER
1. Preparation for installation of automatic belt tension adjuster assembly;
CAUTION:
-
Always use a vertical type pressing tool to move the adjuster rod down.
-
Do not use a lateral type vise.
-
Push adjuster rod vertically.
-
Be sure to slowly move the adjuster rod down applying a pressure of 294 N (30 kg, 66 lb).
-
Press-in the push adjuster rod gradually taking more than three minutes.
-
Do not allow press pressure to exceed 9,807 Nm (1,000 kg, 2,205 lb).
-
Press the adjuster rod as far as the end surface of the cylinder. Do not press the adjuster rod into the cylinder. Doing so may damage the cylinder.
-
Do not release press pressure until stopper pin is completely inserted.
1. Attach the automatic belt tension adjuster assembly to the vertical pressing tool.
