Legacy Brighton Wagon AWD F4-2.5L SOHC (2000)
Measure resistance between connector (3I) terminal and chassis ground.
CHECK: Is the resistance more than 1 M ohms?
YES:
Go to step 5Q7.
NO:
Replace side airbag harness (RH).
5Q7: SIDE AIRBAG HARNESS (RH) INSPECTION
Measure resistance between connector (3I) terminal and chassis ground.
CHECK: Is the resistance more than 1 M ohms
YES:
Go to step 5Q8.
NO:
Replace side airbag harness (RH).
5Q8: SIDE AIRBAG HARNESS (RH) INSPECTION
Measure resistance between connector (3I) terminal and chassis ground.
CHECK: Is the resistance more than 1 M ohms?
YES:
Replace side airbag sensor (RH).
NO:
Replace side airbag harness (RH).
52 - Side Airbag Sensor (LH) Is Faulty
DIAGNOSIS:
-
Side airbag sensor (LH) is faulty.
-
Side airbag harness (LH) is faulty.
CAUTION: Before performing diagnostics on airbag system, turn ignition switch "OFF", disconnect battery ground cable and then wait at least 20
seconds.
5R1: SIDE AIRBAG HARNESS (LH) INSPECTION
1. Disconnect connector (AB21) from ELR with pretensioner on LH side.
2. Disconnect connector (AB19) and (AB20) at below front seat on LH side. (Side airbag equipped vehicle)