Legacy Brighton Wagon AWD F4-2.5L SOHC (2000)
Side Airbag Module: Service and Repair
Side Airbag Harness
REMOVAL AND INSTALLATION
1. Turn ignition switch off.
2. Disconnect ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove front seat and then roll up floor mat.
4. Remove console box.
5. Disconnect two 12-pin yellow connectors from airbag control module.
6. Remove side airbag sensor and then disconnect connector from side airbag sensor.
7. Detach clips and then remove side airbag harness.
8. Installation is in the reverse order of removal.
