Legacy Brighton Wagon AWD F4-2.5L SOHC (2000)
NO:
Replace side airbag harness.
5W5: SIDE AIRBAG HARNESS SHORTED TO GROUND CIRCUIT INSPECTION
Measure resistance between test harness I or I2 connector (3I) terminal and chassis ground.
CHECK: Is the resistance more than 1 M ohms?
YES:
Go to step 5W6.
NO:
Replace side airbag harness.
5W6: SIDE AIRBAG HARNESS SHORTED TO GROUND CIRCUIT INSPECTION
Measure resistance between test harness I or I2 connector (3I) terminal and chassis ground.
CHECK: Is the resistance more than 1 M ohms?
YES:
Replace airbag control module.
NO:
Replace side airbag harness.
65 - ELR W/ Pretensioner (RH) Circuit Is Short/Power Supply
DIAGNOSIS: ELR with pretensioner (RH) circuit is shorted to power supply.
CAUTION: Before performing diagnostics on airbag system, turn ignition switch "OFF", disconnect battery ground cable and then wait at least 20
seconds.
5X1: ELR WITH PRETENSIONER INSPECTION
1. Disconnect connector (AB26) from ELR with pretensioner RH side, and connect (AB26) to test harness F connector (1F).
2. Connect airbag resistor to test harness F connector (3F).
3. Connect battery ground cable and then turn ignition switch to ON (engine off). Observe airbag warning light.
CHECK: Does the airbag warning light come on for about 7 seconds, then go out and stay out?
YES:
Replace ELR with pretensioner RH side.
