Legacy Brighton Wagon AWD F4-2.5L SOHC (2000)
Emergency Locking Retractor: Service and Repair
Front Seat Belt / ELR With Pretensioner
REMOVAL AND INSTALLATION
WARNING: Replace ELR with pretensioner worn by occupants of a vehicle that has been in a serious accident. The entire assembly should be replaced
even if damage is not obvious.
CAUTION:
-
Do not strike, drop, or apply any other impact to ELR with pretensioner.
-
If oil, grease, or water adheres to ELR with pretensioner, wipe it off immediately with a dry cloth.
-
Do not allow current to flow through or voltage to reach ELR with pretensioner. Do not use a circuit tester to check resistance of ELR with
pretensioner.
-
Wear gloves and goggles during this operation and wash hands afterwards.
-
If ELR with pretensioner activates, discard it and replace with new one.
-
Do not expose ELR with pretensioner to high temperature or fire.
-
Do not attempt to disassemble or repair ELR with pretensioner.
-
When an undeployed ELR with pretensioner has to be disposed of in a case such as vehicle scrapping, be sure to deploy it with the procedure
described in "DISPOSAL OF PRETENSIONER" before the disposal.
1. Disconnect ground cable from battery.
2. Fold backrest all the way forward, then move front seat all the way forward.
3. Remove center pillar lower trim.
4. Removal order of front seat belt is as follows:
1. Disconnect "YELLOW" connector (H).
2. Remove anchor cover (A).
3. Loosen shoulder anchor bolt (B), then detach shoulder anchor from center pillar.
4. Remove bracket (D) and bracket (E).
5. Detach webbing guide (C).
6. Turn over the floor mat, then remove bolt (F).
7. Remove bolt (I), then detach ELR (G).
5. Installation is in the reverse order of removal.
CAUTION:
-
The left and right ELR's are not mutually interchangeable because different sensors are used.
-
Be careful not to twist belts during installation.
