Legacy Brighton Wagon AWD F4-2.5L SOHC (2000)
3. Disconnect connector (AB17) from airbag control module and connect it to test harness I or I2 connector (1I).
4. Disconnect connector (AB23) from side airbag sensor (LH) and connect it to test harness G connector (1G).
5. Measure resistance between test harness I or I2 connector (3I) terminal and test harness G connector (3G) terminal.
CHECK: Is the resistance less than 10 ohms?
YES:
Go to step 5R2.
NO:
Replace side airbag harness (LH).
5R2: SIDE AIRBAG HARNESS (LH) INSPECTION
Measure resistance between test harness I or I2 connector (3I) terminal and test harness G connector (3G) terminal.
CHECK: Is the resistance less than 10 ohms?
YES:
Go to step 5R3.
NO:
Replace side airbag harness (LH).
5R3: SIDE AIRBAG HARNESS (LH) INSPECTION
Measure resistance between test harness I or I2 connector (3I) terminal and test harness G connector (3G) terminal.
CHECK: Is the resistance less than 10 ohms?