Legacy Brighton Wagon AWD F4-2.5L SOHC (2000)
Constant Velocity Joint Boot: Service and Repair
Rear DOJ and BJ Boots
REMOVAL
1. Disconnect ground cable from battery.
2. Lift-up vehicle, and remove rear wheel cap and wheels.
CAUTION: Be sure to loosen and retighten axle nut after removing wheel from vehicle. Failure to follow this rule may damage wheel bearings.
3. Unlock axle nut.
4. Remove axle nut.
5. Remove rear differential assembly.
6. Remove rear drive shaft.
7. Remove DOJ and BJ boots from drive shaft.
INSTALLATION
1. Install DOJ and BJ boots to drive shaft.
2. Install rear drive shaft.
