Legacy GT LTD Sedan AWD F4-2.5L DOHC (1998)
Acceleration/Deceleration Sensor: Service and Repair
A: REMOVAL AND INSTALLATION
1. Turn ignition switch to OFF.
2. Remove console box.
3. Disconnect connector from G sensor.
4. Remove G sensor from body.
5. To install, reverse the removal procedure.
CAUTION: Do not drop or bump G sensor.
B: INSPECTION WITH CIRCUIT TESTER
27B1: Check G Sensor
1. Turn ignition switch to OFF.
2. Remove G sensor from vehicle.
3. Connect connector to G sensor.
4. Turn ignition switch to ON.
5. Measure voltage between G sensor connector terminals.
Connector & terminal (P11) No. 2 (+)-No. 3 (-)
CHECK: Is the voltage 2.3+0.2 V when G sensor is horizontal?
Yes: Go to step 27B2
NO: Replace G sensor.
27B2: CHECK G SENSOR
Measure voltage between G sensor connector terminals.
Connector & terminal (P11) No. 2 (+)-No. 3 (-)
CHECK: Is the voltage 3.9+/-0.2 V when G sensor is inclined forwards to 90°?
