subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

ABOUT US
Roll Connector <--> [Clockspring Assembly / Spiral Cable, Air Bag]|Description and Operation|Page 5011 > < Roll Connector <--> [Clockspring Assembly / Spiral Cable, Air Bag]|Description and Operation|Page 5009

Legacy GT LTD Sedan AWD F4-2.5L DOHC (1998)

Page 2
background image

7. Using steering puller, remove steering wheel.

CAUTION:  Do not allow connector to interfere when removing steering wheel.

8. Remove steering column covers.
9. Removing two retaining screws, remove combination switch.

CENTERING ROLL CONNECTOR

Note: Before installing steering wheel, make sure to center roll connector built into combination switch.

1. Make sure that front wheels are positioned straight ahead.
2. Install steering gearbox, steering shaft and combination switch properly. Turn roll connector pin (A) clockwise until it stops.
3. Then, back off roll connector pin (A) approximately 2.65 turns until "Arrow" marks aligned.

CAUTION:  Failure to do this might damage roll connector.

INSTALLATION

Roll Connector <--> [Clockspring Assembly / Spiral Cable, Air Bag]|Description and Operation|Page 5011 > < Roll Connector <--> [Clockspring Assembly / Spiral Cable, Air Bag]|Description and Operation|Page 5009