Legacy GT LTD Sedan AWD F4-2.5L DOHC (1998)
DIAGNOSIS:
-
Side airbag sensor (RH) is faulty.
-
Side airbag sensor is different.
CAUTION: Before performing diagnostics on airbag system, turn ignition switch OFF, disconnect battery ground cable and then wait at least 20
seconds.
5K1: CHECK IF TROUBLE CODE 16 IS INDICATED.
Confirm flashing trouble code according to "BASIC DIAGNOSTICS PROCEDURE".
CHECK: Is airbag warning light trouble code 16 indicated?
YES:
Replace side airbag sensor (RH).
NO:
Perform clear memory.
25 Side Airbag Sensor (LH) Is Faulty
DIAGNOSIS:
-
Side airbag sensor (LH) is faulty.
-
Airbag main harness is faulty.
CAUTION: Before performing diagnostics on airbag system, turn ignition switch OFF, disconnect battery ground cable and then wait at least 20
seconds.
After 20 seconds elapse, remove instrument panel lower cover, and disconnect (AB3) and (AB8), (AB9) and (AB10).
5N1: AIRBAG MAIN HARNESS INSPECTION
1. Disconnect connector (AB17) from airbag control module and connect it to test harness E connector (1E).
2. Disconnect connector (AB23) from airbag control module and connect it to test harness G connector (1G).
3. Measure resistance between test harness E connector (3E) terminal and test harness G connector (3G) terminal.
CHECK: Is the resistance less than 10 Ohms?
YES:
Go to step 5N2.
NO:
Replace airbag main harness.
5N2: AIRBAG MAIN HARNESS INSPECTION.
Measure resistance between test harness E connector (3E) terminal and test harness G connector (3G) terminal.
CHECK: Is the resistance less than 10 Ohms?