Legacy GT LTD Sedan AWD F4-2.5L SOHC (2001)
CAUTION: Place a wooden block as shown in Figure to prevent damage to piston.
5. Remove piston seal from caliper body cylinder.
6. Remove lock pin boot and guide pin boot.
ASSEMBLY
14 inch TYPE
1. Clean caliper body interior using brake fluid.
2. Apply a coat of brake fluid to piston seal and fit piston seal in groove on caliper body.
3. Apply a coat of brake fluid to the entire inner surface of cylinder and outer surface of piston.
4. Apply a coat of specified grease to boot and fit in groove on ends of cylinder and install piston boot onto cylinder.
Grease:
NIGLUBE X-2 (Part No. 003606000)
5. Insert piston into cylinder.
CAUTION: Do not force piston into cylinder.
6. Position boot in grooves on cylinder and piston.
7. Apply a coat of specified grease to lock pin and guide pin outer surface, cylinder inner surface, and boot grooves.
Grease:
NIGLUBE RX-2 (Part No. 003606000)
