Legacy GT LTD Sedan AWD F4-2.5L SOHC (2001)
4.
Place the syringe into the overflow reservoir and push the coolant out of the syringe.
5.
Shake the bottle of cooling system conditioner until all contents are thoroughly mixed.
6.
Pour the entire bottle of cooling system conditioner into the radiator.
NOTE:
Do NOT pour the cooling system conditioner into the overflow reservoir. The conditioner Will settle at the bottom of the reservoir and not mix in the
cooling system.
7.
Reinstall the original radiator cap.
8.
Remove rags from around the radiator filler neck.
9.
Start the vehicle and let it run until the engine is warm. This ensures the conditioner circulates and there are no air pockets in the cooling system.
Service Procedure on a HOT Engine
1.
Turn the ignition key to the "ON" position (engine off).
2.
Turn the air conditioning "ON" to cycle the cooling fans. Leave the air conditioning "ON" for approximately two (2) minutes. This will lower the
pressure in the cooling system.
NOTE:
The pressure relief on a "HOT" engine is approximate. Caution should always be taken when removing the radiator cap on a "HOT" engine.
Additional A/C "ON" time may be required to relieve cooling system pressure properly.
3.
Turn off the air conditioning.
4.
Return the ignition key to the LOCK ("OFF") position.
5.
Follow procedure for COLD engine listed above.
RECALL CAMPAIGN IDENTIFICATION LABEL
Type or print the necessary information on a Recall Campaign identification label. The completed label should be attached to the vehicle's upper radiator
support.
CLAIM REIMBURSEMENT AND ENTRY PROCEDURES
Credit for performing this Service Campaign will be based on the submission of properly completed repair order information. Dealers may enter the
applicable claim information through their Dealer Communications System.
Listed below is claim entry information:
Add Engine Cooling System Conditioner - Use the following information for claim submission:
