Legacy GT LTD Sedan AWD F4-2.5L SOHC (2001)
Caution:
The engine cooling system may be extremely hot and under high pressure. Be sure the cooling system has adequately cooled and properly
depressurized before removing the heater hose. Refer to the engine section of the applicable Subaru Service Manual for proper engine cooling system
servicing procedures.
SERVICE PROGRAM IDENTIFICATION LABEL
Type or print the necessary information on a Service Program identification label. The completed label should be attached to the vehicle's upper radiator
support.
A quantity of labels is provided to each dealer with this bulletin. Additional labels are available through your Area / Distributor Service Office.
CLAIM REIMBURSEMENT AND ENTRY PROCEDURES
Credit for performing this Service Program Will be based on the submission of properly completed repair order information. Dealers may enter the
applicable claim information through their Dealer Communications System.
Listed below is claim entry information:
Inspection Only - Verification that the inlet heater hose does not have tape on the protective cover and replacement is not necessary. A total of 0.3 labor
hours will be automatically credited upon claim submission.
Inspection and Replacement - Use the following claim submission information if tape was found on the inlet heater hose protective cover and
replacement was necessary.
For inlet heater hose inspection and replacement enter labor operation 128-281 for 0.1 labor hours The claim will automatically be credited an additional
0.3 labor hours for inspection. A total of 0.4 labor hours will be credited.
Enter applicable part number(s). Parts will be reimbursed at dealer cost plus applicable handling allowance.
