Legacy GT LTD Sedan AWD F4-2.5L SOHC (2001)
1. Adjust tire pressure to specifications.
2. Set vehicle under "curb weight" conditions. (Empty luggage compartment, install spare tire, jack, service tools, and top up fuel tank.)
3. Set steering wheel in a wheel-forward position.
4. Suspend thread from wheel arch (point "A" in figure below) to determine a point directly above center of spindle.
5. Measure distance between measuring point "A" and center of spindle.
CAMBER
Inspection
1. Place front wheel on turning radius gauge. Make sure ground contacting surfaces of front and rear wheels are set at the same height.
2. Set ST into the center of the wheel, and then install the wheel alignment gauge.
ST 927380002 ADAPTER
WHEEL TOE-IN
Inspection
1. Using a toe-in gauge, measure rear wheel toe-in.
Toe-in: 0 ± 3 mm (0 ± 0.12 inch)
2. Mark rear sides of left and right tires at height corresponding to center of spindles and measure distance "A" between marks.
3. Move vehicle forward so that marks line up with front sides at height corresponding to center of spindles.
4. Measure distance "B" between left and right marks. Toe-in can then be obtained by the following equation:
Adjustment
1. Loosen self-locking nut on inner side of link rear.
