Legacy GT LTD Sedan AWD F4-2.5L SOHC (2001)
8. Remove socket from oil pump.
9. Remove bolt from the rear side of oil pump.
10. Disassemble oil pump and bracket by inserting a screwdriver as shown in the figure.
INSTALLATION
1. Install oil pump to bracket.
1. Place oil pump bracket in a vise. Tighten bushing using a 12.7 mm (1/2 in.) type 14- and 21-mm box wrench until it is in contact with oil pump
mounting surface.
CAUTION: Do not place oil pump bracket directly in the vise; use soft pads and hold oil pump lightly to protect the pump.
2. Tighten bolt which installs oil pump to bracket.
Tightening torque: 37.3 Nm (3.8 kgf-cm, 27.5 ft. lbs.)
