Legacy GT LTD Sedan AWD F4-2.5L SOHC (2001)
Clutch Master Cylinder: Service and Repair
Removal and Installation
A: REMOVAL
1. Thoroughly drain brake fluid from reservoir tank.
2. Remove snap pin, clevis pin and separate push rod of master cylinder from clutch pedal.
3. Remove air cleaner case and air intake duct.
4. Remove clutch pipe from master cylinder.
5. Remove master cylinder with reservoir tank.
CAUTION: Be extremely careful not to spill brake fluid. Brake fluid spilt on the vehicle body will harm the paint surface; wipe it off quickly if
spilt.
B: INSTALLATION
1. Install master cylinder to body, and install clutch pipe to master cylinder.
CAUTION: Check that pipe is routed properly.
Tightening torque:
T1: 15 Nm f1.5 kgf-m, 10.8 ft. lbs.)
T2: 18 Nm (1.8 kgf-m, 13.0 ft. lbs.)
