Legacy GT LTD Sedan AWD F4-2.5L SOHC (2001)
NOTE: Use 12 Nm (0.47 in) dia. holes in HUB STAND to prevent bolts from tilting.
3. Clean dust or foreign particles from inside the housing.
4. Using ST1 and ST2, press a new bearing into place.
ST1 927400000 HOUSING STAND
ST2 927100000 BEARING REMOVER
CAUTION:
^
Always press outer race when installing bearing.
^
Be careful not to remove plastic lock from inner race when installing bearing.
^
Charge bearing with new grease when outer race is not removed.
Specified grease: SHELL 6459N
5. Using pliers, install snap ring in its groove.
CAUTION: Make sure to install it firmly to groove.
6. Using ST1 and ST2, press inner oil seal until it contacts circlip.
ST1 927410000 OIL SEAL INSTALLER
ST2 927400000 HOUSING STAND
7. Invert ST and housing.
ST 927400000 HOUSING STAND
