Legacy GT LTD Sedan AWD F4-2.5L SOHC (2001)
3. Clean housing interior completely. Using ST1 and ST2, press bearing into housing.
CAUTION:
^
Always press outer race when installing bearing.
^
Be careful not to remove plastic lock from inner race when installing bearing.
^
Charge bearing with new grease when outer race is not removed.
^
Do not apply pressure more than 30 kN (3.1 ton, 2.8 US ton, 3.1 Imp ton).
4. Using plier, install snap ring.
CAUTION: Ensure snap ring fits in groove properly.
5. Using ST1 and ST2, press outer oil seal until it comes in contact with snap ring.
CAUTION: Do not apply pressure more than 3.92 kN (0.4 ton, 0.4 US ton, 0.4 Imp ton).
6. Invert both ST1 and housing.
7. Using ST2, press inner oil seal into housing until it touches bottom.
ST1 927430000 HOUSING STAND
ST2 927460000 OIL SEAL INSTALLER
