Legacy L Wagon AWD F4-2.2L SOHC (1997)
Front Cross-Member: Service and Repair
Removal
REMOVAL
1) Disconnect ground cable from battery.
2) Loosen front wheel nuts.
3) Lift-up vehicle, and remove front tires and wheels.
4) Remove both stabilizer and jack-up plate.
5) Disconnect tie-rod end from housing.
6) Remove front exhaust pipe.
7) Remove front transverse link from front crossmember and body.
8) Remove nuts attaching engine mount cushion rubber to crossmember.
9) Remove self-locking nuts connecting steering U/J and pinion shaft.
10) Lift engine by approx. 10 mm (0.39 in) by using chain block.
11) Support crossmember with a jack, remove nuts securing crossmember to body and lower crossmember gradually along with steering gearbox.
CAUTION: When removing crossmember downward, be careful that tie-rod end does not interfere with DOJ boot.
