Legacy L Wagon AWD F4-2.2L SOHC (1997)
3) Set the front wheels or rear wheels on the brake tester and set the select lever's position at "neutral".
4) Operate the brake tester.
5) Perform sequence control.
(1) Turn ignition switch ON.
(2) The ABS warning light comes on.
(3) Depress the brake pedal within 0.5 seconds after the warning light goes out so that the brake tester registers a pressure equal to the initial
value.
CAUTION: Do not depress the clutch pedal.
NOTE: The engine must not be operating.
6) Hydraulic unit begins to work; and check the following working sequence.
(1) The left front wheel performs decompression, holding, and compression in sequence, and subsequently the right front wheel repeals the cycle.
(2) Simultaneously both right and left rear wheel perform decompression, holding, and compression in sequence.
7) Read values indicated on the brake tester and check it the fluctuation of values, when decompressed and compressed, meet the standard values.
-
In case of hydraulic unit plunger piston malfunction:
8) After checking, also check if any irregular brake pedal tightness is felt.
9) In case of AWD vehicles, remove the spare fuse from the FWD connector in the engine compartment to return to the original AWD state.
Sequence Control
SEQUENCE CONTROL
Under the sequence control, after the hydraulic unit solenoid valve is driven, the operation of the hydraulic unit can be checked by means of the brake
tester or pressure gauge.
Operational Guidelines of the Sequence Control
1) Connect diagnosis terminals to 3 terminals (K) and 6 terminals (L) of the diagnosis connector beside driver seat heater unit.
2) Set the speed of all wheels at 4 km/h (2 MPH) or less.
3) Within 0.5 seconds after the ABS warning lamp goes out, immediately after the ignition switch is turned to on, depress the brake pedal and hold.
