Legacy L Wagon AWD F4-2.2L SOHC (1997)
8) When TCS sequence control cannot be started (by system malfunction, etc.), the message shown in the figure will be displayed.
NOTE: Read the trouble codes. Repair faulty parts.
Conditions For Completion Of TCS Sequence Control
When the following conditions develop, the TCS sequence control stops and ABS and TCS warning lights come on while the ABS and TCS function
will then stop. The brake system functions as a conventional brake system.
1) When the speed of at least one wheel reaches 10 km/h (6 MPH).
2) When terminal No.4 is separated from ground. (When select monitor is not used.)
3) When the brake pedal is depressed during sequence control and the braking lamp switch is set to ON.
4) When TCS OFF switch is released. (When select monitor is not used.)
5) After completion of the TCS sequence control.
6) When output signal to break TCS control is emitted from ECM.
7) When malfunction is detected.
NOTE: When malfunction has been detected and the TCS sequence control operation has stopped, the trouble codes are stored in memory.
