Legacy L Wagon AWD F4-2.2L SOHC (1997)
6. The message shown in the figure is displayed as follows:
(1) When using the brake tester, depress brake pedal with braking force of 981 N (100 kg, 221 lbs.).
(2) When using the pressure gauge, depress brake pedal so as to make the pressure gauge indicate 3,432 kPa (35 kg/cm sq., 498 psi).
CAUTION: Do not depress the clutch pedal.
7. When the message shown in the figure is displayed, press ENT key.
8. Check points will be displayed on scan tool.
9. When ABS sequence control cannot be started (by system malfunction, etc.), the message shown in the figure will be displayed.
NOTE: Read the trouble codes. Repair faulty parts.
10. After completion of ABS sequence control, turn ignition switch OFF.
CONDITIONS FOR COMPLETION OF ABS SEQUENCE CONTROL
When the following conditions develop, the ABS sequence control stops and ABS operation is returned to the normal control mode.
1. When the speed of at least one wheel reaches 10 km/h (6 MPH).
2. When terminal No. 3 or No. 6 are separated from diagnosis terminals. (When scan tool is not used.)
3. When the brake pedal is released during sequence control and the braking lamp switch is set to off.
4. When brake pedal is depressed after ignition key is turned to ON, and before ABS warning light goes out. (When scan tool is not used.)
5. When brake pedal is not depressed after ignition key is turned to ON, and within 0.5 seconds after ABS warning light goes out. (When scan tool is
not used.)
6. After completion of the sequence control.
7. When malfunction is detected. (When scan tool is used.)
CONDITIONS FOR ABS SEQUENCE CONTROL