Legacy L Wagon AWD F4-2.2L SOHC (1997)
7. Check points will be displayed on scan tool.
8. When ABS sequence control cannot be started (by system malfunction, etc.), the message shown in the figure will be displayed.
NOTE: Read the trouble codes. Repair faulty parts.
9. After completion of ABS sequence control, turn ignition switch OFF.
CONDITIONS FOR COMPLETION OF ABS SEQUENCE CONTROL
When the following conditions develop, the ABS sequence control stops and ABS and TCS function will then stop. The brake system functions as a
conventional brake system.
1. When the speed of at least one wheel reaches 10 km/h (6 MPH).
2. When terminal No. 4 is separated from ground. (When scan tool is not used.)
3. When the brake pedal is released during sequence control and the braking lamp switch is set to off.
4. After completion of the sequence control.
5. When malfunction is detected.
NOTE: When malfunction has been detected and the ABS sequence control operation has stopped, the trouble codes are stored in memory.
CONDITIONS FOR ABS SEQUENCE CONTROL
