Legacy L Wagon AWD F4-2.2L SOHC (1997)
If the distance is more than specifications, there is a possibility that air is in the brake line. Bleed air from the brake line.
17) Turn ignition switch OFF.
18) Disconnect select monitor or diagnosis terminal.
19) Add brake fluid to the required level (MAX. level) of reserve tank.
20) As a final step, test run the vehicle at low speed and apply brakes relatively hard 2 to 3 times to ensure that brakes provide normal braking
action on all four wheels without dragging and uneven braking.
Conditions For Air Bleeding Control
Conditions For Completion of Air Bleeding Control
When any of the following conditions occurs, ABS and TCS warning lights illuminate. Air bleeding control stops, while the ABS and TCS function
will then stop. The brake system functions as a conventional brake system.
1) When the speed of at least one wheel reaches 10 km/h (6 MPH).
2) When terminal No.4 is separated from diagnosis terminal. (When select monitor is not used.)
3) When pump motor remains ON for two minutes.
4) When TCS valve remains open for two minutes.
5) When outlet valve remains closed for two minutes.
6) When malfunction is detected.
NOTE: When a malfunction is detected the air bleeding operation stops and the trouble codes are stored in memory.
Air Bleeding Control With Diagnosis Connector
AIR BLEEDING CONTROL WITH DIAGNOSIS CONNECTOR
1) Connect diagnosis terminals to terminal No.4 of the diagnosis connector beside driver's seat heater unit.
