Legacy L Wagon AWD F4-2.2L SOHC (1997)
2. Gradually supply compressed air via caliper body brake hose to force piston out.
CAUTION:
^
Place a wooden block as shown in Figure to prevent damage to piston.
^
Do not apply excessively high-pressure.
3. Remove piston boot.
4. Remove piston seal from caliper body cylinder.
5. Remove lock pin sleeve and boot from caliper body.
6. Remove guide pin boot.
INSPECTION
1. Repair or replace faulty parts.
2. Check caliper body and piston for uneven wear, damage or rust.
3. Check rubber parts for damage or deterioration.
ASSEMBLY
1. Clean caliper body interior using brake fluid.
2. Apply a coat of brake fluid to piston seal and fit piston seal in groove on caliper body.
3. Apply a coat of brake fluid to the entire inner surface of cylinder and outer surface of piston.
4. Apply a coat of specified grease to boot and fit in groove on ends of cylinder and install piston boot onto cylinder.
Grease: NIGLUBE RX-2 (Part No. 003606000) or equivalent.
5. Insert piston into cylinder.
CAUTION: Do not force piston into cylinder.
6. Position boot in grooves on cylinder and piston.
7. Apply a coat of specified grease to guide pin, outer surface, sleeve outer surface, cylinder inner surface, and boot grooves.
Grease: NIGLUBE RX-2 (Part No. 003606000) or equivalent.
