Legacy L Wagon AWD F4-2.2L SOHC (1997)
ABS SEQUENCE CONTROL
1. Under the ABS sequence control, after the hydraulic unit solenoid valve is driven, the operation of the hydraulic unit can be checked by means of
the brake tester or pressure gauge.
2. ABS sequence control can be started by diagnosis connector or scan tool.
OPERATIONAL GUIDELINES OF THE ABS SEQUENCE CONTROL WITH ABS DIAGNOSIS CONNECTOR
1. Connect diagnosis terminals to terminals No. 3 and No. 6 of the diagnosis connector beside driver's seat heater unit.
2. Set the speed of all wheels at 4 km/h (2 MPH) or less.
3. Turn ignition switch OFF.
4. Within 0.5 seconds after the ABS warning light goes out, depress the brake pedal and hold it immediately after ignition switch is turned to ON.
CAUTION: Do not depress the clutch pedal.
NOTE:
^
When the ignition switch is set to on, the brake pedal must not be depressed.
^
Engine must not operate.
5. After completion of ABS sequence control, turn ignition switch OFF.
OPERATIONAL GUIDELINES OF THE ABS SEQUENCE CONTROL WITH SCAN TOOL
1. Connect scan tool to data link connector beside driver's seat heater unit.
2. Turn ignition switch ON.
3. Put scan tool to ABS mode.
4. Press F D 1 ENT key.
5. The message shown in the figure is displayed.
