Legacy L Wagon AWD F4-2.2L SOHC (1997)
Combination Switch: Service and Repair
Removal and Installation
With Airbag
Combination Switch
REMOVAL
1. Turn ignition switch off.
2. Disconnect ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove lower cover. Disconnect airbag connector (AB3) and (AB8) below steering column.
CAUTION: Do not reconnect airbag connector at steering column until combination switch is securely re-installed.
4. Disconnect combination switch connectors from body harness connector.
5. Set front wheels in straight ahead position. Remove covers from both sides of steering wheels. Using TORX (R) BIT T30 (Tamper resistant type),
remove four TORX (R) bolts.
6. Disconnect airbag connector and horn connector on back of airbag module. Remove airbag module, and place it with pad side facing upward.
