Legacy L Wagon AWD F4-2.2L SOHC (1997)
8) Place oil pump pulley and lighten pulley nut temporarily.
9) Interconnect pipes C and D.
Tightening torque:
Joint nut
15 ± 5 Nm (1.5 ± 0.5 kg-m, 10.8 ± 3.6 ft-Ib)
CAUTION: If a hose is twisted at this step, the hose may come into contact with some other parts.
10) Connect pipe D from oil tank.
11) Connect pipe C from oil pump.
CAUTION: Use a new gasket.
Tightening torque:
34 ± 5 Nm (3.5 ± 0.5 kg-m, 25.3 ± 3.6 ft-Ib)
12) Tighten bolt A.
Tightening torque:
13 ± 3 Nm (1.3 ± 0.3 kg-m, 9.4 ± 2.2 ft-Ib)
13) Install pulley belt to oil pump.
14) Tighten oil pump pulley nut to the specified torque.
Tightening torque:
61 ± 7 Nm (6.2 ± 0.7 kg-m, 44.8 ± 5.1 ft-Ib)
15) Adjust pulley belt tension.
16) Tighten bolt belt tension.
Tightening torque:
8 ± 2 Nm (0.8 ± 0.2 kg-m, 5.8 ± 1.4 ft-Ib)
17) Install pulley belt cover bracket.
18) Connect minus terminal of battery.
19) Feed the specified fluid and discharge air.
NOTE: Never start the engine before feeding the fluid; otherwise vane pump might be seized up.
