Legacy L Wagon AWD F4-2.2L SOHC (1997)
10. Remove cotter pin and castle nut which secure tie-rod end to housing knuckle arm.
11. Using a puller, remove tie-rod ball joint from knuckle arm.
12. On ABS equipped models, remove ABS sensor assembly and harness in advance.
CAUTION: Be sure to use soft jaws (such as aluminum plates) when placing the mating surfaces of housing and strut in a vise.
13. Remove transverse link ball joint from housing.
14. After scribing an alignment mark on camber adjusting bolt head, remove bolts which connect housing and strut, and disconnect housing from strut.
