Legacy L Wagon AWD F4-2.2L SOHC (1997)
5. Lightly tap the head of front propeller shaft with a copper hammer until center bearing is removed.
CAUTION: Be careful not to damage the thread portion.
Inspection
NOTE: Do not disassemble propeller shaft. Check the following and replace if necessary.
1. Tube surfaces for dents or cracks
2. Splines for deformation or abnormal wear
3. Joints for non-smooth operation or abnormal noise
4. Center bearing for free play, noise or non-smooth operation
5. Oil seals for abnormal wear or damage
6. Center bearing for breakage
Assembly
1. Install center bearing onto front propeller shaft.
2. Align marks and install companion flange.
3. Tighten stake nut until center bearing is set in position.
CAUTION: Be sure to install new stake nut.
Tightening Torque: 270 +/- 25 Nm (199 +/- 18 ft. lbs.).
NOTE: Stake the nut after tightening.
