Legacy L Wagon AWD F4-2.2L SOHC (1997)
CAUTION: The inside of the larger end of BJ boot and the boot groove must be cleaned so as to be free from grease and other substances.
2) Place FTJ boot at the center of shaft.
3) Align alignment marks and install trunnion on shaft.
4) Install snap ring to shaft.
CAUTION: Confirm that the snap ring is completely fitted in the shaft groove.
5) Fill 100 to 110 g (3.53 to 3.88 oz) of specified grease into the interior of FTJ outer race.
6) Apply a coat of specified grease to free ring and trunnion.
7) Align alignment marks on free ring and trunnion and install free ring.
8) Align alignment marks on shaft and outer race and install outer race.
9) Install circlip in the groove on FTJ outer race.
CAUTION: Pull the shaft lightly and assure that the circlip is completely fitted in the groove.
10) Apply an even coat of the specified grease 30 to 40 g (1.06 to 1.41 oz) to the entire inner surface of boot.
11) Install FTJ boot taking care not to twist it.
CAUTION:
-
The inside of the larger end of FTJ boot and the boot groove shall be cleaned so as to be free from grease and other substances.
-
When installing FTJ boot, position outer race of DOJ at center of its travel.
