Legacy L Wagon AWD F4-2.2L SOHC (1997)
Constant Velocity Joint Boot: Service and Repair
Front
REMOVAL
1. Disconnect ground cable from battery.
2. Jack-up vehicle, support it with safety stands (rigid rocks), and remove front wheel cap and wheels.
NOTE: Do not remove axle nut.
3. Remove stabilizer link.
4. Disconnect transverse link from housing.
5. Remove spring pin which secures transmission spindle to DOJ.
CAUTION: Use a new spring pin.
6. Remove DOJ and UFJ boot frolic drive shaft.
INSTALLATION
1. Install DOJ and UFJ boots to drive shaft.
2. Install DOJ on transmission spindle and drive spring pin into place.
CAUTION: Always use a new spring pin.
3. Connect transverse link to housing.
4. Install stabilizer link.
