Legacy L Wagon AWD F4-2.2L SOHC (1997)
3. Insert DOJ spline end into bore of side oil seal, and remove ST.
CAUTION: Do not allow DOJ splines to damage side oil seal.
4. Align DOJ and differential splines.
5. Push housing to insert DOJ into differential.
NOTE: Make sure DOJ is inserted properly
CAUTION: Discard old self-locking nut. Replace with a new one.
6. Connect rear housing assembly to trailing link assembly, and tighten self-locking nut.
7. Connect rear housing assembly to lateral link assembly, and tighten self-locking nut.
8. Connect stabilizer link to lateral link.
9. Install crossmember reinforcement lower to crossmember (4 door model only).
10. Install ABS sensor clamps and parking brake cable bracket.
