subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Case, M/T|Disassembly|Page 3646 > < Case, M/T|Disassembly|Page 3644
Page 2
background image

Replace the insert if deformed, excessively worn, or defective in any way.

OIL SEAL 

Replace the oil seal if the lip is deformed, hardened, damaged, worn, or defective in any way.

O-RING 

Replace the O-ring if the sealing face is deformed. hardened, damaged, worn, or defective in any way.

GEARSHIFT MECHANISM 

Repair or replace the gearshift mechanism if excessively worn, bent, or defective in any way.

DIFFERENTIAL GEAR 

Repair or replace the differential gear in the following cases:
1. The hypoid drive gear and drive pinion shaft tooth surface are damaged, excessively worn, or seized.
2. The roller bearing on the drive pinion shaft has a worn or damaged roller path.
3. There is damage, wear, or seizure of the differential bevel pinion, differential bevel gear, washer, pinion shaft, and straight pin.
4. The differential case has worn or damaged sliding surfaces.

Case, M/T|Disassembly|Page 3646 > < Case, M/T|Disassembly|Page 3644