Legacy L Wagon AWD F4-2.2L SOHC (1997)
8. Combination of transmission case
a. Wipe off grease, oil and dust on the mating surfaces of transmission cases with white gasoline, and apply liquid gasket, and then put case right
side and left side together. Liquid gasket: THREE BOND 1215 or equivalent.
b. Tighten 17 bolts with bracket, clip, etc. as shown in the image.
Tightening torque:
-
8 mm bolt: 25 +/-2 Nm (18.1 +/-1.4 ft. lbs.).
-
* 10 mm bolt: 39 +/-3 Nm (28.9 +/-2.2 ft. lbs.).
NOTE:
-
Insert bolts from the bottom and tighten nuts at the top.
-
Put cases together so that drive pinion shim and input shaft holder shim are not caught up in between.
-
Confirm that counter gear and speedometer gear are meshed.
9. Tighten ball bearing attachment bolts. Tightening torque: 29 +/-3 Nm (21.7 +/-2.2 ft. lbs.).
10. Backlash adjustment of hypoid gear and preload adjustment of roller bearing
