Legacy L Wagon AWD F4-2.2L SOHC (1997)
Connector & terminal / Specified voltage:
(I12) No.1 - Body / 10 ohms - max.
3. CHECK HARNESS CONNECTOR BETWEEN COMBINATION METER AND VEHICLE SPEED SENSOR 2.
1) Disconnect connector from vehicle speed sensor 2.
2) Measure resistance of harness connector between vehicle speed sensor 2 and combination meter.
Connector & terminal / Specified resistance:
(B17) No.1 - (I11) No.2 / 10 ohms max.
(B17) No.2 - (I11) No.3 / 10 ohms max.
4. CHECK VEHICLE SPEED SENSOR 2.
NOTE:
If resistance between terminals of vehicle speed sensor 2 is out of specification, the sensor may have a failure.
If resistance is OK and voltage between terminals of vehicle speed sensor 2 is out of specification, mechanical trouble may be present between
vehicle speed sensor 2 and speedometer shaft in transmission.
1) Disconnect connector from vehicle speed sensor 2.
2) Measure resistance between terminals of vehicle speed sensor 2.
Terminals / Specified resistance:
No.1 - No.2 / 350 - 450 ohms
WARNING:
Be careful not to be caught up by the running wheels.
3) Set the vehicle on free roller, or lift-up the vehicle and support with safety stands.
4) Drive the vehicle at speed greater than 20 km/h (12 MPH).
5) Measure voltage between terminals of vehicle speed sensor 2.
Terminals / Specified voltage:
