Legacy Outback Limited AWD F4-2.5L DOHC (1998)
Evaporator Core: Service and Repair
Removal and Installation
Evaporator Core
REMOVAL AND INSTALLATION
1) Disconnect battery negative terminal.
2) Discharge refrigerant using refrigerant recovery system.
3) Disconnect discharge pipe, suction pipe and grommets.
4) Remove glove box and pocket back panel.
5) Disconnect the harness connector from evaporator.
6) Disconnect drain hose.
7) Remove evaporator mounting bolt and nut.
8) Install the evaporator in the reverse order of removal.
9) Charge refrigerant.
DISASSEMBLY AND ASSEMBLY
1) Remove resistor assembly (1) and remove six screws from evaporator case.