Legacy Outback Limited AWD F4-2.5L DOHC (1998)
2) Installation of timing belt
Align alignment mark on timing belt with marks on sprockets in the numerical order shown in figure. While aligning marks, position timing
belt properly.
WARNING: DISENGAGEMENT OF MORE THAN THREE TIMING BELT TEETH MAY RESULT IN INTERFERENCE
BETWEEN THE VALVE AND PISTON. ENSURE BELT'S ROTATING DIRECTION IS CORRECT.
3) Install belt idler.
WARNING: MAKE SURE THAT THE MARKS ON TIMING BELT AND SPROCKETS ARE ALIGNED.
4) After ensuring that the marks on timing belt and sprockets are aligned, remove stopper pin from tensioner adjuster.
