Legacy Outback Limited AWD F4-2.5L DOHC (1998)
Transmission Position Switch/Sensor: Adjustments
2. Inhibitor Switch
The inhibitor switch allows the back-up lights to turn on when the select lever is in the R range and the starter motor to start when the lever is in the N
or P range.
When driving condition or starter motor operation is erroneous, first check the shift linkage for improper operation. If the shift linkage is functioning
properly, check the inhibitor switch.
< Inspection >
1. Disconnect cable end from select lever.
2. Disconnect inhibitor switch side connector.
3. Check continuity in inhibitor switch circuits with select lever moved to each position.
CAUTION:
Also check that continuity in ignition circuit does not exist when selector lever is in R, D, 3, 2 and 1 ranges.
NOTE:
If inhibitor switch is inoperative, check for poor contact of connector on transmission side. (Plastic body type inhibitor switch)