Legacy Outback Limited AWD F4-2.5L DOHC (1998)
Roll Connector: Testing and Inspection
Inspection and Replacement Standards
A: VEHICLES WHICH BECOME INVOLVED IN A COLLISION
If the vehicle equipped with an SRS airbag system is damaged in a collision, the airbag system parts must be checked and replaced in accordance with
the following standards:
-
After faulty parts are replaced, the warning light operation must be checked.
-
When the ignition switch is turned ON, it lights up for about 7 seconds and then it goes out for at least 30 seconds.
-
The trouble code stored in memory must be erased after the check.
B: COMBINATION SWITCH
1. INSPECTION STANDARD
-
A vehicle damaged in a collision (regardless of whether or not airbag is deployed).
-
The designated trouble code is output during self-diagnosis.
2. REPLACEMENT STANDARD
Combination switch or steering roll connector is deformed or cracked.
C: STEERING WHEEL
1. INSPECTION STANDARD
A vehicle damaged in a collision (regardless of whether or not airbag is deployed).
2. REPLACEMENT STANDARD
-
Check steering wheel insert for cracks or deformities.
-
Check to ensure that new airbag module is properly installed in steering wheel.
-
After installing airbag module, check to ensure that it is free of interference with steering wheel and that clearance between the two is equal at
all points.
D: STEERING COLUMN ASSEMBLY
1. INSPECTION STANDARD
A vehicle damaged in a collision (regardless of whether or not airbag is deployed).
