Legacy Outback Limited AWD F4-2.5L DOHC (1998)
6) Insert rack stopper into cylinder tube until internal groove (on cylinder side) is aligned with external groove (on rack stopper). Turn rack stopper
with ST so that rack stopper hole is seen through cylinder slits.
7) Insert rack stopper into rack housing, and wrap circlip using ST to secure rack stopper in position.
ST 926340001 Wrench
CAUTION: Be careful not to scratch rack while winding circlip.
NOTE: Rotate wrench another 90 to 180° after the end of circlip has been wrapped in.
8) Fit mounting rubber onto rack housing.
2. Valve Assembly
1) Apply genuine grease to pinion gear and bearing of valve assembly.
2) Install packing on valve assembly. Insert valve assembly into place while facing rack teeth toward pinion.
CAUTION: Be sure to use a new packing.
NOTE: Do not allow packing to be caught when installing valve assembly.
3) Tighten bolts alternately to secure valve assembly.
Tightening torque: 25 ± 5 Nm (18.1 ± 3.6 ft. lbs.).
CAUTION: Be sure to alternately tighten bolts.
