Legacy Outback Limited AWD F4-2.5L DOHC (1998)
5.
Drill the 4 outer marks to 7/16 of an inch using a stepped drill bit process, position (A).
6.
Drill the 4 inner marks to 17/64 of an inch using a stepped drill bit process, position (B).
7.
Remove drill bit burrs from drilled holes and paint the bare metal surface.
8.
Use 4 self-locking nuts part # 902350001 and install the dampers to the crossmember.
9.
Install the Rear Differential Front Crossmember in the reverse order of removal.
10.
Confirm the repair by test driving the vehicle.
WARRANTY INFORMATION.