Legacy Outback Ltd Sedan F4-2.5L SOHC (2000)
Cruise Control Actuator: Service and Repair
ACTUATOR
CAUTION:
-
Be careful not to apply excessive load to the wire cable when adjusting and/or installing; otherwise, the actuator may be deformed or damaged.
-
Do not bend cable sharply with a radius less than 100 mm (3.94 in); otherwise, cable may bend permanently, resulting in poor performance.
-
When installing cable, be careful not to sharply bend or pinch the inner cable; otherwise, the cable may break.
1. Remove clip bands from cruise control cable.
2. Loosen nut which secures cruise control cable end to throttle cam and then remove cable from throttle cam.
3. Remove actuator attaching bolts.
4. Remove actuator while disconnecting connector.
5. Installation is in the reverse order of removal.
Tightening torque:
7.4 ± 2.0 N.m (0.7 ± 0.2 kg.m, 5.4 ± 1.4 ft.lb)
NOTE:
A: Must be adjusted when cable end outer is fixed in place, so that gap between throttle cam and lever is 0 - 1 mm (0-0.04 in).
(Must be attached while throttle cam is being pulled b wire cable.)
B: Must be coated evenly on cam end inner connection.
C: Cover must be inserted securely, until tip of cable touches cover stopper.
