Legacy Outback Ltd Sedan F4-2.5L SOHC (2000)
Check body harness.
NOTE: After problem has been eliminated, disconnect connectors (3A) and (4A).
CHECK: Is there anything unusual to body harness?
YES:
Repair body harness.
NO:
Replace airbag warning light bulb or combination meter printed circuit.
5Z4: CHECK POOR CONTACT IN CONNECTOR (AB6).
Check connector (AB6) connected to airbag control module.
CHECK: Is there poor contact in connector (AB6)?
YES:
Repair poor contact in connector (AB6).
NO:
Go to step 5Z5.
5Z5: INSPECTION OF AIRBAG MAIN HARNESS
1. Turn ignition switch "OFF", disconnect battery ground cable and then wait at least 20 seconds, and re-connect connectors (AB1) and (B31).
2. Disconnect connector (AB3) with (AB8) and (AB9) with (AB10), then disconnect connector (AB6) from airbag control module, and connect it to
test harness I or I2 connector (1I).
3. Connect battery ground cable and turn ignition switch "ON", (engine off) and connect connectors (4I) and (5I).
NOTE: After problem has been eliminated, disconnect connectors (41) and (51).
CHECK: Does the airbag warning light come off?
YES:
Go to step 5Z6.
NO:
Replace airbag main harness.
5Z6: GROUNDING CIRCUIT INSPECTION
1. Turn ignition switch "OFF', disconnect battery ground cable and then wait at least 20 seconds.
2. Disconnect connector (AB1) from body harness connector (B31), and connect connector (B31) to test harness A connector (1A).
