Legacy Outback Ltd Sedan F4-2.5L SOHC (2000)
Measure resistance across test harness I or I2 connector (3I) terminal and chassis ground.
CHECK: Is the resistance more than 10 K Ohms?
YES:
Replace airbag control module.
NO:
Go to step 5K4.
5K4: AIRBAG MAIN HARNESS AND FRONT SUB SENSOR HARNESS (RH) INSPECTION
1. Connect test harness I or I2 connector (1I) and connector (AB6).
2. Disconnect connector (AB16) from front sub sensor (RH) and then connect test harness H connector (1H) and connector (AB16).
3. Measure resistance between test harness I or I2 connector (3I) terminal and test harness H connector (3H) terminal.
CHECK: Is the resistance less than 10 Ohms?
YES:
Go to step 5K5.
NO:
Go to step 5K8.
5K5: AIRBAG MAIN HARNESS AND FRONT SUB SENSOR HARNESS
(RH) INSPECTION
Measure resistance between test harness I or I2 connector (3I) terminal and test harness H connector (3H) terminal.
CHECK: Is the resistance less than 10 ohms?
YES:
Go to step 5K6.
