Legacy Outback Ltd Sedan F4-2.5L SOHC (2000)
Measure resistance across test harness H connector (3H) terminal and chassis ground.
CHECK: Is the resistance more than 10 K ohms?
YES:
Perform clear memory.
NO:
Replace front sub sensor (RH).
32 - Front Sub Sensor Harness (LH) Circuit Is Shorted
DIAGNOSIS:
-
Front sub sensor harness (LH) circuit is shorted.
-
Front sub sensor harness (LH) circuit is open.
-
Front sub sensor (LH) is faulty.
-
Airbag control module is faulty.
CAUTION: Before performing diagnostics on airbag system, turn ignition switch "OFF", disconnect battery ground terminal, and then wait at least 20
seconds.
5L1:FRONT SUB SENSOR (LH) AND FRONT SUB SENSOR HARNESS (LH) INSPECTION
1. Disconnect connector (AB6) from airbag control module, and connect it to test harness I or I2 connector (1I).
2. Measure resistance between test harness I or I2 connector (3I) terminal.
CHECK: Is the resistance between 750 Ohms and 1 K ohms?
YES:
Replace airbag control module.
NO:
Go to step 5L2.
5L2: FRONT SUB SENSOR (LH) AND FRONT SUB SENSOR HARNESS (LH) INSPECTION
