Legacy Outback Ltd Sedan F4-2.5L SOHC (2000)
Measure resistance across test harness H connector (3H) terminal and chassis ground.
CHECK: Is the resistance more than 10 K ohms?
YES:
Go to step 5L18.
NO:
Replace front sub sensor (LH).
5L18: FRONT SUB SENSOR (LH) INSPECTION
Measure resistance across test harness H connector (3H) terminal and chassis ground.
CHECK: Is the resistance more than 10 K ohms?
YES:
Perform clear memory.
NO:
Replace front sub sensor (LH).
51 - Side Airbag Sensor (RH) Is Faulty
DIAGNOSIS:
-
Side airbag sensor (RH) is faulty.
-
Side airbag harness (RH) is faulty.
CAUTION: Before performing diagnostics on airbag system, turn ignition switch "OFF", disconnect battery ground cable and then wait at least 20
seconds.
5Q1: SIDE AIRBAG HARNESS (RH) INSPECTION
1. Disconnect connector (AB26) from ELR with pretensioner on RH side.
2. Disconnect connector (AB24) and (AB25) at below front seat on RH side. (Side airbag equipped vehicle)
3. Disconnect connector (AB18) from airbag control module and connect it to test harness I or I2 connector (1I).
4. Disconnect connector (AB28) from side airbag sensor (RH) and connect it to test harness G connector (1G).
