Legacy Outback Ltd Sedan F4-2.5L SOHC (2000)
Perform the following inspection procedures and repair or replace defective parts.
ASSEMBLY
1. Reassembly precautions
1. Whenever O-rings, oil seals, and snap rings are removed, they must be replaced with new ones.
2. Thoroughly wash parts and allow to dry. They must be kept free from cleaning oil and dust.
3. Reassembly procedure must be performed in clean place. Ensure that parts are kept away from waste threads or other dust particles.
4. Cleaning oil tends to stay inside the front casing. Remove it completely by blowing compressed air.
5. Ensure that parts are free from rust. (Use specified hydraulic oil for rust prevention after cleaning and drying.)
6. Reverse the sequence of disassembly procedures.
2. Apply grease to oil seal and inner surface of front casing (at bearing location).
CAUTION: Make sure that the front body internal surfaces are free from damage.
3. Temporarily install rear cover to front body.
4. Attach ST to front body. Using a press, install oil seal.
ST 341 99AE030 INSTALLER
5. Install pump pulley to front body.
6. Using ST, place oil pump in a vise.
ST 341 99AE020 ATTACHMENT
7. Remove rear cover.
