Legacy Outback Ltd Sedan AWD F4-2.5L SOHC (2001)
3. Install rear sensor harness brackets in the original positions and install harness on the relic
4. Place a thickness gauge between ABS sensor's and tone wheel's tooth face. After standard clearance is obtained over the entire perimeter, tighten
ABS sensor on rear arm to specified torque.
ABS sensor standard clearance:
0.44 - 0.94 mm (0.0173 - 0.0370 inch)
Tightening torque:
32 Nm (3.3 kgf-m, 24 ft. lbs.)
CAUTION: Check the marks on the harness to make sure that no distortion exists. (RH: white, LH: yellow)
NOTE: If the clearance is outside specifications, readjust.
5. After confirmation of the ABS sensor clearance, connect connector to ABS sensor and install fuel tank cover.
6. Connect connector to battery ground cable.
