Legacy Outback Ltd Sedan AWD F4-2.5L SOHC (2001)
Side Air Bag: Service and Repair
Removal and Installation
Side Airbag Module
REMOVAL
CAUTION:
-
The side airbag module cannot be detached from the front seat assembly.
-
When replacing side airbag module, replace front seat assembly.
INSTALLATION
Refer to Front Seat.
Side Airbag Harness
REMOVAL
1. Turn ignition switch OFF.
2. Disconnect the ground cable from the battery, and wait for at least 20 seconds before starting work.
3. Remove front seat.
4. Remove console box.
5. Roll up floor mat, and then disconnect two 12-pin yellow connectors from airbag control module.
6. Disconnect connector from side airbag sensor.
7. Detach clips, and then remove side airbag harness.
INSTALLATION
Install in the reverse order of removal.